SOS speaks a tiny bit on 1.2.62

[★ SOS]

What is the difference between "Current walltiles" and "Complete walltiles"?

 

Do PTM and then use Convert to WT. It just fills the entire area with the "single" tile.

 

Selecting big areas with control+a sometimes gives an out-of-range error.

[🜲 Samapico]

mm yeah... the three options of 'convert selection to walltiles'

I tried explaining them via the tooltiptext... and i'm sure there could be more appropriate names to them

 

basically:

 

o All tiles : transforms ALL tiles in the selection to the walltileset you select ; it will consider all tiles as walltiles

 

 

o Current walltiles : transforms only tiles that currently belong to ONE OF THE walltile sets... so basically it transforms all tiles currently defined as "walltiles" into the walltile set you select

 

 

o Complete walltiles : will check if a tile is part of the tileset you select, if so, it will redraw it correctly according to the surrounding tiles of the same walltiles set. For example, you could draw a base with tile X, then create a walltileset with tile X and other tiles, and then use that option. It will redraw every tile X (and other tiles that also belong to the walltile set) as walltiles.

 

 

i'm sure there must be a better way to name them to avoid confusion as the last two only have a small difference

 

note that Switch / Replace tiles will work with walltiles soon (it already kinda works, but not completely) , so replacing a single walltileset to a different one will be done through Switch / Replace

 

also, note that these things were done yesterday and were not throughly tested yet, there are bugs that I know of, and there surely is other bugs that should be fixed soon

 

feel free to suggest ways to make that better / easier to understand, or more possible options for converting selection to walltiles

 

Selecting big areas with control+a sometimes gives an out-of-range error.

that probably has to do with a > 1024 display... shouldnt be too hard to fix